So Youve Purchased Fiat 500 Replacement Key Cost Now What

Fiat 500 Replacement Key Fob

It's possible to replace the battery if your 500 remote key fob isn't working. If you replace the battery but it's still not working, the problem may be elsewhere.

At United Locksmith, we specialize in making new keys for old automobiles. We have all the tools and parts necessary for this type of service.

Dead Coin Battery

The most common reason your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The battery inside the key fob can be depleted quickly if you don't use frequently enough. If your remote has started to show signs of a loss of range or stopped functioning and the battery is not working, it could be dead.

Metal clips hold the battery securely inside the key fob. If the clips are not tightly secured, they could result in contact problems that will prevent your remote to receive power. Use a flathead screwdriver to remove the retaining clip and remove the old battery. Be sure to choose a replacement battery with the same kind of voltage, size, and specification as the original battery.

The key fob may be damaged or corroded due to exposure to water. Even a quick bath in soapy, warm water can cause damage to the chip. Keep your key fob dry.





Water Damage

If your key fob isn't functioning correctly, it could be due to water damage. The rubber seals on key fobs stop them from being damaged by a tiny drizzle or splash of water. However, fiat doblo key fob replacement to keep the keys out of the ocean, washing machine, and pool.

The key fob comes with an electronic chip inside it that sends a signal car's immobilizer system. This is the reason why your 500 can start or lock, however if the chip gets wet, it's unable to longer work.

You can try cleaning your key fob's internal electronics with isopropyl alcohol or an electronic cleaner to determine whether they're still in good condition. However, it is probably better to purchase a replacement from a dealer rather than trying to repair the key fob that has been submerged in salt water.

While a replacement fob might cost you a little bit of money, it is much cheaper than paying for your Fiat 500 to be towed to the dealer and repaired! You can also fix it yourself by following some simple steps. Make sure you have the correct battery type prior to opening your keyfob. You can find step-bystep directions for any car keyfob online.

Faulty Chip

The chip inside the key fob communicates with your car's immobiliser unit to ensure your car is only able to start when the correct key is inserted. If the chip is damaged, or corrupted in any way your car will not start.

Damage to the water or a dead battery are the most common reasons for defective chips. It is recommended to leave the job to a professional locksmith, who can replace the chip in a short time and at a an affordable cost.

If your key fob stops working after exposure to clean water from the tap or rain, take off the battery and wipe down the electronic component with a towel to ensure it is fully dry before putting it back in. If the key fob does not work it's likely to be an issue with the chip and is required to be replaced.

Some people will go to their dealer when they are in need of an entirely new Fiat key fob, however this could be a costly option. If you are looking for a low-cost solution to have your Fiat key fob repaired then look no further than United Locksmith. We have all the tools and knowledge required to fix your Fiat fob quickly and professionally. way.

Faulty Receiver Module

Fiat key fobs transmit a signal up to 50 feet to the vehicle, which will unlock and lock the doors (and start the vehicle in case of automatic transmissions). However, there are some things that can cause the fob to cease functioning. These include a dead coin battery, water damage buttons, worn ones or a problem with the receiver module and signal interference, or an electronic chip that is malfunctioning.

If the fob was placed in the pocket that has been subject to extreme trauma (such as being dropped on a hard floor or being washed in the washing machine) it might not be able to communicate with the Body Control Module (BCM) of the vehicle. This is because the BCM is an extremely secure system that will only accept signals from a genuine key, and not from any other.

If this is the case, you have to replace your fob. A locksmith professional can handle every aspect of the replacement process as well as programming a new one for the 500. In fact, they can provide you with a duplicate key that works just the same as the original fob (and costs a fraction of the cost).